SW22
12
User
manual
P1630830G
To clear the queue of weighted press the button
and confirm with
Using the
▼
button you can view the entire list.
3.7.5 - Reprint Last ticket
It is possible to reprint the last receipt accomplished by pressing the button
for 3 sec. ; will
be repeated printing of the last operation: first weighing, or weighing or weighing a single
second.
3.7.6 - Print Subtotal
At the end of a sequence of weighings, the operator may ask to view and print the subtotal, ie
the sum of the weighted up to that time.
If you press and hold for 3 sec. button
,
appears on the display for 3 seconds the value of
the total in memory, and if a printer is connected, the subtotal printing operation is performed
according to the programming mode active.
After this the subtotal is reset and its value is added to the total.
3.7.7 - Print grand total
The Grand Total is the sum of all SubTotal executed since the last reset of the same.
If you press and hold for 3 sec. button
(with Subtotal = 0) the display will show for 3
seconds the value of the Total General.
If a printer is connected, a receipt is issued according to the programming mode activated.
The operator also has the option to cancel the data displayed, or just to keep it in memory in
which case the next Total Partial still be added to the current value.
To proceed with the reset value of the press
, while
allows you to exit without
resetting.
3.7.8 - Print Total article
The third operation of Total that the terminal SW-22 provides the operator, is that of Total for
Item, ie the sum of all items divided by code.
Press keys
and
in sequence and prints the total weight of all items with a value other
than 0; in this case, the reset request concerns the total of all codes (ENTER = YES; ESC =
NO).
3.8 - Peak Detection weight
By selecting this mode, you can display the value of a weight (PEAK) detected during weighing.
This feature is particularly useful to measure, for example, the breaking load of the materials.
Pressing
and
F1
is enabled the peak display mode ; the display shows the message -
PEAK every 5 seconds, alternating the maximum weight reached up to that point.
Pressing
and
F1
again you return to the standard view of the weight on the balance.
3.9 - Batch with recipes
Selecting the operating mode "Recipes" you can run an assay with a formula consisting of a
maximum of two components.
The maximum number of recipes can be stored is 50.
Press keys
and
Set
in sequence you enter the planning phase of the recipes.
The display shows "r 00"; set the number of prescription to program and confirm with
; set
the values in the sequence corresponding to the two components; if a component is not used,
set the value to 0.0.
After the inclusion of the second component, the display shows the number of recipe following
the current one; press
to confirm or
to terminate.
During the normal operating mode, to select the recipe number to be performed, dial the
number from the keypad and confirm with
COD
.
The cycle start command is given by pressing
or closing the first of the two digital inputs of
the I / O or serial port using the appropriate command.
The batch can be performed either in LOAD or in DISCHARGE.
