(
)
3-7. Programming Over Voltage Limit(OVL)
Users are able to change 0V to maximum voltage. However if user input voltage in OVL,
from this point users are able to change 0V to UVL voltage.
OVL Level Value below can be different.
▌Power Switch ON
Check "**OUTPUT OFF**" Mode is displayed after input Power ON.
▌Before setting-up OVL, voltage limit should be lower than UVL setting value.
Therefore, set-up voltage first.
▌Use cursor key to move on to voltage range, and use encoder switch
to change the voltage value.
Voltage cannot rise more than the Protection Level in Protection (OVP/UVL
will be displayed and voltage will be set-up protection level value
/OVL) If it tries to rise more than protection level, "PROTECTION LIMIT"
will be displayed and voltage will be set up protection level value.
▌Press PROTECT Key to set-up OVL Level.
LCD Display Description
PROTECT> 1.OVP
▌Use right cursor key to move on to OVL Menu.
LCD Display Description
PROTECT> 4.OVL
▌
Press PROTECT Key once more
"
Protect> 4.OVL
" condition.
LCD Display Description
OVL SET> 9.450V
▌Use cursor key to change the value.
▌Rotate encoder switch to change Level value.
OVL Level cannot fall more than present setting value which prevents
p
g
p
users mistake.
▌When it is done, press PROTECT Key to save.
LCD Display Description
Changed
Return to previous page after displaying above message.
To cancel
▌To cancel, press I/O LOCAL Key or wait for 10 seconds.
Wait 10 Sec
LCD Display Description
Cancel…
Read reference "1-6. Check after Power ON" "Earliest Setting Value"
Note
- 26 -
