Ochsner AIR HAWK 518, Design And Installation Manual

Page: 29 / 60

PIA_982030_AIR_HAWK_518_in_EN | www.ochsner.com 29
Appliance installation
Material damage
Note the following points when carrying the appli-
ance with the pre-installed transport aids:
»
When lifting and carrying the appliance, make
sure that all 4 transport aids are pulled evenly
and at the same time.
»
Ensure that the appliance casing is not dam-
aged during transport.
»
The transport aids are not suitable for lifting
by crane.
WARNING
The permitted carrying load for each person is re-
stricted by law.
»
Observe all applicable national and regional
regulations and provisions.
»
Follow the transport instructions on the appli-
ance.
Material damage
When being transported with the appliance casing
dismantled, sensitive components will be exposed.
»
Take care when transporting the appliance.
9.1.2 Positioning the appliance
»
Position the appliance at the intended installation
location.
»
Use the pre-installed transport aids (2 lifting slings at
the front and 2 lifting handles at the rear) to slide and
tilt the appliance.
»
Observe minimum clearances.
Note
On the underside of the indoor unit, there are four
plastic glides with rubber mounted threaded pins
(without nuts). Discrepancies in floor height of up
to 6 mm can be compensated for.
»
Align the appliance horizontally.
1 Lifting sling
2 Mounting bolt
3 Appliance frame
»
After the appliance has been placed in position,
remove the two lifting slings at the front of the
appliance.
»
Undo and remove the two mounting bolts and remove
the two lifting slings.
»
Then screw the two supplied pan head screws into
the appliance frame.
9.1.3 Disassembling the appliance casing
»
Undo and remove the 4 knurled screws for the appli-
ance casing at the rear of the appliance.
»
Undo and remove the 2 fixing screws for the control
box cover, on the rear of the appliance.
»
Slide back the control box cover. Lift the control box
cover up and away.