Ochsner AIR 80 C13A, Operating And Installation Instructions

Page: 6 / 68

BA_AIR_80_C13A_AIR_80_C22A_OTE3_SW5x_EN_V07.docx Page 6 of 68
3.3.3 Evaporator
Consists of copper tubing in an Aluminium fin
package. This is suitable for outside installation.
The intake air must
not be subjected to aggres-
sive material (Ammoniac, Sulphur, Chlorine etc.)!
3.3.4 Liquid separator with sump
The liquid separator protects the compressor
from liquid hammering, especially when the re-
frigerant circuit is reversed. Due to the large-sized
liquid sump, an optimum supercooling and thus
an optimum performance is achieved, even at
differing air temperatures (summer opera-
tion/cooling, winter operation/heating, hot water
and de-icing).
3.3.5 Condenser
The heat exchangers are made of stainless steel.
Their special construction allows high stability.
The plate heat exchanger is insulated all round
against condensate and heat loss. The quality of
the water in the heating system must be ensured
by means of testing to VDI 2035 resp. ÖNORM H
9195-1 both before commissioning as well as
during operation. The results are to be docu-
mented in the system log.
4 Installation
Delivery
The heat pump is delivered on a one-way palette
and packed in foil (ARA Licence No. 7910). See
Chapter 12 for the removal of the inside unit
from the one-way palette.
Report any transport damage immedi-
ately on receiving the heat pump!
Transport damage that is reported be-
latedly cannot be recognised as a
claim!
Transport
The heat pump is to be stored and transported
packaged up. Careful transport at an angle up to
45° is permitted over short distances. Ambient
temperatures from
– 20°C to +45°C are permitted
both for transport and storage. The standard
packaging offers no weather or seawater protec-
tion.
Transport damage can only be recognised if this is
made known to the driver of the delivery vehicle
during, or immediately after unloading.
Tilting dimension of the inside unit
The tilting dimension of the heat pump is 209cm:
Fig. 2: Titling dimension of the heat pump
Installation of the inside unit
The heat pumps AIR 80 C13A and AIR 80 C22A
can be installed in any room, provided they are
dry, not endangered by frost and noise opti-
mised.