Sauna & Steam
Oceanic Saunas 01902 450 550 [email protected]
8
Infrared Sauna Assembly
8. Wiring
8.1. Keypad and Temperature Sensor
i. Do not turn any power on until the cabin
has been fully installed.
ii. Refer to the parts list for a wiring
schematic.
iii. Sit the control box on the roof in the
iv. Then pull out of the hole
on the inside.
v. To mount the heaters fix
2 x 30mm the 2x 30mm
screws into the two
indicated holes. Leave
them protruding slightly so
you can hang the heaters
off them, similar to how
you would fit a picture
frame or clock.
specified position.
iv. The temperature sensor and keypad will already be fitted onto there panels, route these across
the roof, through the channels made in the frame to the control box connections and plug them
in.
8.2. Wall Heaters
i. For the heaters use the correct length of cable as shown on the schematic.
ii. Plug the one end into the control as shown below.
iii. Then route the other end down from the roof into the walls panels.
