Sauna & Steam
Oceanic Saunas 01902 450 550 [email protected]
12
Infrared Sauna Assembly
10. Bench Assembly
Important Safety Information.
The benches may have to support the body weight of several bathers. It is important that
they are correctly assembled; the holes for all screws must be predrilled to prevent the timber
splitting. To tighten the screws use a hand held screwdriver or an electrically operated one with
a torque setting that allows the screw to be fully tightened but not to spin as spinning reduces
the holding power of the screw.
Note the use of a good quality PVA adhesive (not supplied) will improve the durability of the
benches.
Maximum loadings;
Up to 1200 mm no centre support 2 x 12.5 stone people
Up to 1800 mm with 1 extra support 3 x 12.5 stones people
Before commencing the construction of the benches find the specification sheet for the sauna
you are building. This will give detail of the correct quantities and positions of timbers and
fixings.
i. Screw the supporting frame together using the 4 large brackets and 20mm screws.
iv.
There is a channel cut out of the back of
the trim to hide the cable, pin the trim into
place, make sure you don’t fix this trim
anywhere near the centre of panel as you
could pin into a cable.
