Sauna & Steam
Oceanic Saunas 01902 450 550 [email protected]
4
Infrared Sauna Assembly
4. Base
i. Lay out the 32 x 32mm base section as shown below with the correct 9mm spacings.
ii. Check the base drawing on the parts list supplied
iii. Check the base with a spirit level, you may need to use packers to get a level base.
iv. Use a set square or measure corner to corner with a tape measure to ensure the base is square.
v. To make the following stages easier we recommend that you fix the base to the floor, this is
completely optional and is not required for the structural integrity of the cabin.
2. General
Important Notice: Unless you ordered a “low height wiring kit” it is not possible to install our Infra-
Red Sauna Cabins with a height lower than 2200mm as the wiring is all done above the sauna.
Before you begin the assembly work we recommended that you read through these instructions
completely in order to familiarise yourself with the procedure.
Each model of sauna has it’s own dedicated parts list, make sure you locate this before continuing.
This sauna cabin is for indoor use only.
Infrared Saunas can be erected onto a level floor that can be vinyl, ceramic, concrete, or wood, but
preferably not carpet.
3. Requirements
You will require the following items:-
i. The easiest and fastest way to trim this cabin is to use a brad nailer, electric, gas or air all are ok.
The brads we supply are straight 18 gauge 25mm and 40mm length. If you don’t have a nailer
you can pilot & screw or break the individual brads off the strips and use a hammer.
ii. A powered drill/screw driver with drill bits, PH2 and PZ2 driver bits
iii. 4mm drill and countersink tool
iv. Spirit level
v. Hammer
vi. Hand Saw or an electric mitre or cross cut saw is advised for cutting trim to give a professional
finish.
vii. Sand Paper
viii. Window packers or alternatively make some using cross cut saw from spare timber.
ix. Optional: - if it is possible to fix the unit to the floor you will need a hammer drill and raw plugs
