Sauna & Steam
Oceanic Saunas 01902 450 550 [email protected]
26
Infrared Sauna Assembly
21. Keypad Operation
i. Once all the cables has been correctly connected to the control box and the box and the power cable
has either been plugged into the wall socket (domestic) or hard wired to the isolated mains supply
(commercial) you can press the ‘On/Off’ button on the keypad to turn on the infrared sauna.
ii. The keypad should now display a time and a temperature and L7 should be orange to show that the
lamps are warming up. The time displayed is the length of time that the sauna will stay on for before
turning itself off. The can be can be increased or decreased as described below. The temperature
shown is the current air temperature inside the cabin, the maximum air temperature can be increased
or decreased as described in point iv.
iii. Adjusting the time. Press the ‘Set’ button once. The time will now flash. Increased or decrease the time
using the blue and red arrow keys. Once the correct time is flashing press the Enter key to save the
selection. If you do not press the Enter key the time will not be saved and will revert to the previous
setting. The maximum time you can select is 1hour and 30 minutes for a session.
iv. Adjusting the temperature. Press the ‘Set’ button twice. The temperature will now start flashing.
Increase or decrease using the blue and red arrow keys. Once correct press the ‘Enter’ button to save.
The maximum air temperature is 60 degrees for the infrared sauna.
v. The keypad will remember the time and the temperature that you selected on your previous session
when you turn the sauna on.
vi. To activate the other functions such as turning on the lighting and speakers, press the associated key
the correct number of times as described in the table on the previous page. The associated LED will
light up to show you that the light or speakers are on.
vii. Overheat light. All saunas are fitted with a built-in thermal cut-out that trips automatically if the
temperature in the sauna rises above a safe level. The reset button is located in the remote thermostat.
If you cannot ascertain what caused the increase in sauna temperature, do not attempt to reset the
sauna, but either notilfy Oceanic Saunas Ltd, or call in a qualified electrician.
Please read the Infrared Sauna Operation Manual for full instructions on how to use and look after
your infrared sauna.
If you encounter any difficulty with this assembly procedure or think we could have explained
anything more clearly we would welcome your comments, please call T: 01902 655425 or T: 01902
871127 technical help line.
