Sauna & Steam
Oceanic Saunas 01902 450 550 [email protected]
19
Infrared Sauna Assembly
15. Internal Trim
15.2. Corner Uprights
Measure, cut to size and fix four of 19x19 corner
mould and fix with 32mm brads into the corners of
the room as shown.
15.1. Cornice
Measure, cut to size and fix the 19 x 19 corner
mould and fix to into place using a brad nailer
and 32mm brads provided. (
If you have already
fitted the cornice from the roof stage please
continue to the next step. ) Important: Do not pin
near cables, ie the centre of each heater panel.
15.3. Door
i. If you have installed the door on the end face of a side panel then you will need to remove the
standard magnetic catch and fit the piece of timber below shown in blue which has a magnetic
catch installed half way down. This timber part is supplied with every door. Make sure the curved
edge is towards the back so you have a flush finish across the front, pin in place with 25 or 35mm
brad nails.
You can then trim the other edge using 32x9 overlap.
Magnetic catch
Counter Plate
