Configuring your machine for a wireless network
25
3
Configuring your machine for a wireless network
3
There are three methods to configure your wireless network machine; by using the machine control panel
(recommended), using the SecureEasySetup™ software and using the automatic installer application on the
CD-ROM.
Using the Setup Wizard from the control panel
3
You can configure your print server by using the
Setup Wizard
function. This is located in the
LAN
menu
on the machine’s control panel. See to the steps below for further information.
IMPORTANT
If you have previously configured the wireless settings of the machine, you must reset the network LAN
settings before you can configure the wireless settings again. Press
Menu
,
7
,
0
for
Factory Reset
,
Reset
and choose
Yes
to accept the change. The machine will restart automatically.
a
Write down the wireless network settings of your access point or wireless router.
SSID (Service Set ID or Network name)
WEP key (if needed)
WPA-PSK (if needed)
b
Plug the AC power cord into an AC outlet. Turn the power switch on.
c
Press
Menu
on the control panel of the cx2100.
d
Press
a
or
b
to choose
LAN
.
Press
OK
.
e
Press
a
or
b
to choose
WLAN
.
Press
OK
.
f
Press
a
or
b
to choose
Setup Wizard
.
Press
OK
.
g
If the following message appears, press
a
or
b
to choose
On
, then press
OK
. The wired network interface
will become inactive with this setting.
72.WLAN
WLAN Enable?
a
On
b
Off
Select
ab
or OK
h
The machine will search for your network and display a list of available SSIDs. You should see the SSID
you wrote down earlier. If the machine finds more than one network use
a
or
b
key to choose your
network, then press
OK
. Go to
l
.
If your access point is set to not broadcast the SSID, you will have to manually add the SSID name.
Go to
i
.
