Oce 9700, User Manual

Page: 47 / 220

Basic copy jobs 47
Copying on cut sheet material
If you want to copy a job on a paper type and/or size that is not available on
one of the paper rolls, it can be convenient to manually feed sheets of paper
instead of changing one of the paper rolls. The sheet feed is a special slot just
above the paper roll drawers on the engine. You can insert pre-cut copy
material in this slot, one sheet at a time.
Note:
Only use paper as specified in ‘Copy material that can be used’ on
page 184.
▼
▼ ▼
▼
Copying on pre-cut sheets
1
Open the ‘General’ card in the ‘Machine’ section.
2
Press the ‘Sheet feed’ button. The display will look as follows:
3
Select any required other settings.
4
Enter the number of copies using the numeric buttons.
5
Feed the original.
6
Press the start button.
7
Take your sheet of copy material to the side of the printer engine that contains
the sheet feed.
8
Use both hands to align the copy material in accordance with the format
indication and the sticker on the manual feed table.
9
Move the paper forward in the nip of the roller. This must cause an ample paper
bulge over the full width of the page.
....
....
...
....
...
...
....
...
....
...
..
....
....
...
....
...
...
....
...
....
...
..
....
....
...
....
...
...
....
...
....
...
..
....
....
...
....
...
...
....
...
....
...
..
....
....
...
....
...
...
....
...
....
...
..
..................................................................................
Access to
ial Access to
Page
................
Copy
................
Program
Copies
0
................
Finishing
................
Machine
General
Controller
Reset
counter
Interrupt
job
Sheet feed
Accounting
.....................................................
User ID:
Account ID:
0
0 0
Interrupt
job
Rewind
Sheet feed