8
- GB -
Set-up and start-up
Please refer to „Bulb replacement“ when fitting the bulb. When set up above the water level, maintain a safety distance
of at least 50 cm from combustible material. Ensure a safe seating. Do not cover the unit. Danger of fire! A swivel
bracket (5) can be fitted to the spotlight by means of a screw connection. Position the unit such that it does not present
a hazard for anybody. When fitting in the pond, fasten the unit on a suitable base by means of the swivel bracket. The
ground stake (6+7) can be used when installing the unit out of the water. Connect the power plug of the spotlight to the
socket of the transformer bush (3+4). Connect the transformer to the power supply. Check the spotlight function.
Replacing the bulb (1)
Adhere to the safety instructions! Disconnect the power! Undo the screw-connection of the top section. Ensure that no
moisture can enter the unit. Remove the top section and the glass, clean, if necessary. Take the bulb out of the hous-
ing. Important! Only original bulbs from OASE may be used. Insert new bulb (do not touch, use a cloth or similar).
Check the O-ring and replace, if damaged. Reassemble the unit in the reverse order, connect to the power supply and
perform a function check.
Repair
In the event of damage to the cables or the housing, the transformer (2) cannot be repaired and, therefore, has to be
replaced.
Cleaning
Adhere to the safety instructions! Carry out the work steps as specified under 'Replacing the bulbs'. Only use water
and a soft brush. Ensure that no moisture can enter the unit.
Wearing parts
Bulbs are wearing parts and are excluded from the warranty.
Disposal
Dispose of the unit in accordance with the national legal regulations.
Malfunctions
Malfunction Cause
Remedy
Power supply interrupted
Check power supply
Bulb defective
Replace bulb
Lamp does not light up
Bulb contacts corroded
Clean contacts
Light intensity decreases
Lamp glass soiled
Clean
Water in the spotlight housing
Seal defective
Check sealing rings and replace, if necessary
Light flickers
Contacts corroded
Clean lamp pins
29437-10-13_GA_Lunaqua 35.pdf 8
22.10.2013 12:13:13
