NXP Semiconductors QorIQ T1040, User Manual, Page: 61 / 68

=> protect off all
Un-Protect Flash Bank # 1
=> erase 0xeff40000 0xefffffff
.... done
Erased 4 sectors
=> cp.b 0x1000000 0xeff40000 0xc0000
Copy to Flash...
9....8....7....6....5....4....3....2....1....done
• RCW programming on alternate bank (from U-Boot prompt)
For T1040RDB, use rcw/t1040rdb/RR_P_66/ rcw_1400MHz.bin
NOTE
This RCW can change depending upon the requirements.
=> tftp 1000000 <rcw>.bin
=> protect off all
=> erase 0xec000000 0xec01ffff
=> cp.b 0x1000000 0xec000000 $filesize
• FMan microcode programming on alternate bank (from U-Boot prompt)
=> tftp 0x3000000 <fsl_fman_ucode>.bin
=> protect off all
Un-Protect Flash Bank # 1
=> erase 0xebf00000 ebf1ffff
. done
Erased 1 sectors
=> cp.b 3000000 0xebf00000 10000
Copy to Flash...
9....8....7....6....5....4....3....2....1....done
• U-Boot binary programming on alternate bank (from U-Boot prompt)
=> tftp 0x1000000 u-boot.bin
=> protect off all
Un-Protect Flash Bank # 1
=> erase 0xebf40000 0xebffffff
.... done
Erased 4 sectors
=> cp.b 0x1000000 0xebf40000 0xc0000
Copy to Flash...
9....8....7....6....5....4....3....2....1....done
4.6.2 Flashing eSPI boot images
The steps for flashing and updating images for eSPI are as follows:
1. Write
PBL1.bin
(created using QCS tool) at offset 0:
Chapter 4 Software configuration
QorIQ T1040 Reference Design Board User Guide, Rev. 0, 06/2015
Freescale Semiconductor, Inc. 61