Operating Manual and Inspection Book
POWER LIFT HL 2.30 NT / HL 2.35 NT / HL 2.40 NT
20100016 OPI
- 48 -
Version 1.1
9 Operating lever
10 2x Allen key operating lever
11 Oil filling opening
• Loosen and remove the plastic part of the operating lever (9) of both Allen screws (10)
• Loosen and remove the unit cover.
• Unscrew the oil filling opening (11).
• Fill 9 litre hydraulic oil (HLP 32).
• Raise the lift approx. 1 m by pushing the operating lever (9).
The lift rails can be lifted at different times!
• Hang in the lifting arms and secure them.
• Push the operating lever forwards and raise the lift to its uppermost end position.
• Push and hold the operating lever for another 60 seconds so air can escape from the system and the
overflow procedure equalises the lift to each other.
For first commissioning, it is normal to have a different start up and a large "shaking" in
the uppermost position. Air trapped in the system must be completely removed first.
• Afterwards lower the lift to its lowest position. Pull the operating lever (9) and hold it until the lifting arm
is completely lowered.
The oil level should be approx. 30-40 mm below the oil fill opening. Do not fill the oil tank
up to the upper edge, as otherwise during lowering the oil return line can pull oil out of
the line and afterwards result in a very slow lifting at the upper range.
• After commissioning, the sticker (first filling) can be removed.
9
10
10
11
Summary of Contents for HL 2.30 NT
Page 2: ......
Page 94: ...Notes ...
