Nuna Prym, Manual, Page: 14 / 236

14 13
PRYM instructions PRYM instructions
EN EN
Product Use
DO NOT
install this enhanced child restraint on
vehicle seats that face sideways or rearward with
respect to the moving direction of the vehicle.
(1)-1
DO NOT use the rearward facing enhanced child
restraint systems in seating positions where there is
an active frontal airbag installed. Death or serious
injury may occur. (1)-2 Please reference vehicle
owner’s manual for more information.
It is recommended to install this enhanced child
restraint on the rear vehicle seat. (1)-3
This enhanced child restraint is suitable for vehicle
seats with i-Size ISOFIX anchor points. (2)
DO NOT
install this enhanced child restraint on
vehicle seats unstable during installation.
Installation
1 -
After placing the base on the vehicle seat, pull the
load leg downward to floor. (3)
2 -
Fit the ISOFIX guides into the ISOFIX anchor
points. (4) The ISOFIX guides can protect the
surface of the vehicle seat from being torn. They
will also guide the ISOFIX connectors.
3 -
Press the ISOFIX adjustment button on either side
of the base, then pull out the ISOFIX connectors.
(5)
Make sure that both ISOFIX connectors are
securely attached to their ISOFIX anchor points.
There should be two audible clicks and the colors
of the indicators on the both ISOFIX connectors
should be completely green.
(6)-1
After successfully installing the ISOFIX
connectors, press the ISOFIX adjustment buttons
again while pushing the seat back until it comes
in contact with the vehicle seat back. (6)
Check to make sure the enhanced child restraint
is securely installed by pulling on the both ISOFIX
connectors.
4 -
There are 9 adjustable positions for ISOFIX. Press
the ISOFIX adjustment buttons and push the base
back against the vehicle seat until tight.
5 -
After placing the enhanced child restraint on the
vehicle seat, extend the load leg to floor.
(7)
The
load leg indicator will show green when installed
correctly, red means it is installed incorrectly.
(7)-3
The load leg has 24 positions. When the load leg
indicator shows red this means the load leg is in the
wrong position.
Make sure the load leg is secure by pressing
down on the front of the enhanced child restraint.
To shorten the load leg, squeeze the load leg
release button and pull the load leg upwards.