37
2. You can change the current song by
holding down the
Lullabies on/off
button
. This automatically goes on to the
next song.
The previously selected lullaby will play in
a loop for about 20 minutes and will then
automatically switch off.
5.4 Nightlight
The baby unit’s soft nightlight helps your
baby recognise things in the dark room,
which it finds soothing.
• You turn the nightlight on or off by briefly
pressing the
Nightlight on/off
button
.
Notes:
– If you press and hold the
Nightlight
on/off
button
, this activates the
Paging function (see "Call function of
parent unit“ on page 37).
– The nightlight can also be activated
from the parent unit
"6.11 Nightlight" on page 42).
5.5 Call function of parent unit
If you misplace the parent unit and are
unable to find it, you can use the “Paging”
function to search for it.
1. You activate the function by holding
down the
Nightlight on/off
When the function has been activated,
the baby unit will beep once and the
parent unit will then begin to emit a
continuous series of beeps that will
enable you to locate it.
Notes:
– The parent unit emits these beeps at
the volume you previously selected
(see "6.5 Adjusting the volume control"
on page 39). If the volume is set to its
lowest level, then the beeps will also be
extremely quiet.
– If the parent unit is muted then it will
not emit any beeps; and the baby unit
will emit a double beep to indicate this:
one beep: Search function has been
activated
two beeps: the search function cannot
be activated because there is currently
no connection to the parent unit. The
parent unit is either switched off, or out
of range, or currently muted.
2. You turn the function off either by again
pressing and holding the
Nightlight on/
off
, or by pressing any of the
buttons on the located parent unit.
6. Operating the parent unit
6.1 Switching the parent unit
on and off
on or off, press
:
– when you hear a beep and the
Power
LED 20
lights up, the parent unit is
switched on;
– when you hear a beep and the
Power
LED 20
goes out, the parent unit is
switched off.
6.2 Indicator LEDs
on the
shows the state of the
. It:
– lights up green when it has a
connection;
– flashes green when the baby unit is in
Eco-Mode and indicates that your
baby is sleeping peacefully;
– lights up red if the connection has
broken down or the baby unit is
switched off.
Notes:
– If the baby unit
is in Eco-Mode and
the parent unit moves out of range, the
connection indicator
will light up
red. You will also hear a beep every
30 seconds.
