39
• The battery symbol is also
always displayed and shows the
battery’s current charge level
(see "4.4 Power supply" on page 34).
• The loudspeaker symbol always
shows you the device’s current
volume setting (see "6.5 Adjusting
the volume control" on page 39
and "6.6 Mute setting" on page 39).
If no bars are shown, then the device is
currently muted (see "6.6 Mute setting"
on page 39).
6.4 The time display and
setting the clock
1. To set the clock, simultaneously hold
down the volume
VOL + 15
and
VOL - 16
buttons for at least 3 seconds.
The time display will flash.
2. Use the
VOL +
button
to set the
hours.
3. Use the
VOL -
button
to set the
minutes.
When you have set up the desired time on the
display, wait a few seconds until it stops
flashing. This means that your setting has
been stored.
Note:
In the event of a power failure you
may need to set up the time afresh.
6.5 Adjusting the volume
control
• You can use the
VOL + 15
and
VOL - 16
buttons to set the volume at which you
hear the sounds emitted by the parent
unit.
Each time you press one of the buttons
you will hear a beep at the volume that is
currently set and the corresponding
LEDs
will be illuminated The louder
your chosen setting, the louder will be
any beeps and the more LEDs will light
up.
The display also shows a number
of bars indicating the current
volume setting. The louder your
chosen setting, the louder the
unit will beep and the more bars
will appear.
Note:
When the VOX function is set to
low sensitivity (see "6.8 Using the VOX
function to adjust the transmission
sensitivity" on page
40), then quiet
sounds will not be transmitted regardless
of the volume setting. This means that
turning up the volume will not enable you
to hear anything more. If you want to hear
more of the sounds from the nursery you
will need to increase the transmission
sensitivity by selecting a higher VOX
level.
6.6 Mute setting
The parent unit can be “MUTED”. Sounds
from the nursery will then no longer be
transmitted.
1. Press the
button repeatedly
until no more beeps are heard.
No further sounds will be transmitted.
The display
shows the
loudspeaker symbol with no
bars.
The LEDs
will continue to indicate the
noise level in the nursery. The more LEDs
are lit the louder are the noises in the
nursery.
2. You can cancel the mute setting by
pressing the
VOL + 15
key.
3. If the parent unit is muted and you
activate the talk-back function, the
volume will automatically return to the
first level.
4. If you have activated the vibrating alarm
and muted the parent unit, then if your
baby cries loudly you will be alerted by the
vibration as well as the LED display
Caution!
If you mute the parent unit and also activate
the lullabies then you will no longer have any
