42
– If you choose to switch the lullabies on
anyway, there may be a delay of up to
30 seconds before they begin. In Eco-
Mode, the activation command is not
transmitted until the next range check
is carried out (see "Range check in
Eco-Mode“ on page 35).
6.11 Nightlight
The Nightlight function provides for a soft
dim light in the nursery.
Note:
You can alternatively switch the
nightlight on and off from the baby unit itself
(see "5.4 Nightlight" on page 37).
1. You activate the function by briefly
pressing the
Nightlight on/off
.
The nightlight
switches on.
The display
shows the
lightbulb symbol.
2. You switch the function off by briefly
pressing the
Nightlight on/off
button
again.
The nightlight
switches off.
The lightbulb symbol disappears.
Nightlight in Eco-Mode
Please note!
There are a number of special
features while the babyphone is in Eco-
Mode (see "4.5 Eco-Mode and FULL-ECO-
CONTROL" on page 35):
• The “Nightlight” function is temporarily
deactivated so that you do not
inadvertently disturb baby.
In this case the lightbulb
symbol will flash while the
FULL-ECO-CONTROL function
checks the connection
between the two units.
– To prevent the nightlight from switching
on later, you can again press the
Nightlight on/off
to
immediately cancel the function. The
flashing symbol will then disappear
from the display.
– If you choose to switch on the
nightlight anyway, there may be a delay
of up to 30 seconds before this
happens. In Eco-Mode, the activation
command is not transmitted until the
next range check is carried out (see
"Range check in Eco-Mode“ on
page 35).
6.12 Room temperature
The correct room temperature is particularly
important for baby’s healthful sleep. The
baby unit of this NUK babyphone therefore
has an integrated temperature sensor.
The temperature in the nursery is always
shown on the display
and is updated
automatically.
Note:
Since the temperature sensor is inside
the baby unit it is important that you do not
cover it or place it near the heating. Direct
sunlight may also affect the reading.
The baby unit checks the room temperature
and sends warnings to the parent unit. The
following signals are displayed on the
display of the parent unit:
Display Significance
/
Action
LO
flashing
The temperature has fallen below
the lower threshold of 10 °C.
The room temperature has
reached an extremely critical
level and urgent action is
required to increase the
temperature in the nursery.
10 °C
to
15 °C
flashing
This temperature is too low for
baby to sleep properly.
Check the heating and adjust it if
necessary.
15 °C
to
30 °C
This temperature is suitable for
baby to sleep properly.
30 °C
to
35 °C
flashing
This temperature is too high for
baby to sleep properly.
Check the ventilation or air-
conditioning and adjust it if
necessary.
