Nuga NM-5000P, User Manual

Page: 13 / 24

How to Install the Product
NM-­5000P
How to Install the Product
Prepare product
components
Take out the remote controller,
power cord, external projector,
projector pocket, and low frequency
pad.
Connect to the connector bay
ྙ Remote controller
ྚ External projector
ྛ Low frequency pad
Connect components sequentially.
Connect the mat cable
Connect the power supply cable for
the sub mat to both the main and
sub mats as shown in the picture.
Turn on the power supply
in the product
Turn on the power switch after the
power supply cord is connected to the
power input on the side of the main mat.
Set temperature to the
sub heater
Turn the dialer to set the desired
temperature in the sub heater
attached to the side of the sub mat.
Tighten the product frame
to the mat
Attach the connecting band after
placing and tightening both the main
and sub mats to the product frame.
Caution
Turn off the power switch when the
power is connected.
Otherwise, it might cause failure.
Caution
Keep the groove upward to the
cable connection.
Malfunctions might occur, if the groove is not
aligned accurately during the cable connection.
HIGH
LOW
ⴘⴙⴚ