MC-II
Plus
WP-PM Flow Analyzer
Appendix D
D-4
May
2005
Prompt
Where
Displayed
Definition
Prog no
Upper line
Displays the current version of firmware incorporated
in the MCII
Plus
on the lower line of the display. This
display is shown momentarily during power up, reset
or when entering the calibration mode. This prompt
requires no action.
PULS.div
Upper line
The display prompts for the selection of the pulse
output divisor (only if the
PULS.oUt
function was
enabled). The present pulse output divisor is shown
on the lower line of the display.
PULS.Lng
Upper line
The display prompts for the selection of the pulse
output length in milliseconds (only if the
PULS.oUt
function was enabled). The present pulse length
setting is shown on the lower line of the display.
PULS.oUt
Upper line
The display prompts during calibration to enable or
disable the pulse output function by toggling the
on
or
oFF
selection shown on the lower line of the
display. It is also displayed as an
Error
message
indicating a pulse output rate that is too fast or a
pulse overlap.
rAtE
Upper line
Is displayed as an
Error
message indicating a rate
overflow, which may be corrected by scaling the rate
multiplier.
rAtE.dLY
Upper line
The display prompts for the selection of the flow rate
filter. The lower line of the display shows the present
rate filter setting.
rAtE d.P
Upper line
When the
USEr
units of measure was previously
selected, the display prompts for the selection of the
rate multiplier decimal point. The present decimal
point position is displayed on the lower line of the
display.
rAtE.Eng
Upper line
When BBL, GAL or M3 was previously selected for
the units of measure, the display prompts for the
selection of the rate units of measure. The present
rate units of measure are displayed on the right side
of the display unless
USEr
is selected, which is
displayed on the lower line of the display.
rAtE.FAC
Upper line
When the
USEr
units of measure was previously
selected, the display prompts for the selection of the
rate multiplier. The present rate multiplier is
displayed on the lower line of the display.
Summary of Contents for MC-II Plus Panel Mount
