
23
Type
Base tolerance e
0
[mm]
Parallelism tolerance e
1
[mm]
AXC60
0,010
0,018
AXC80
0,010
0,020
AXC100 / AXF100
0,020
0,022
AXC120
0,020
0,030
Table 3.2____ Mounting tolerances of parallel Linear Axis
Figure 3.2 ___ Dynamic load capacity of Linear Axis related to the monting tolerances
Figure 3.1 ___ Tolerances of parallel Linear Axis
The mounting surfaces of the Linear Axis, as well as for the cross traverse should be machined in the assembly area in a single setup
or should be adjustable. It should be aimed for the straightness transverse to the moving direction (Figure 3.1) of the mounting surfaces
base tolerances e
0
and the parallelism tolerances e
1
of the Linear Axis from Table 3.2.
If a machining of the mounting surfaces to above-mentioned requirement are not provided or this value is exceeded by the deflection
of the cross traverse, a control of parallelism must be made and, if necessary a correction must be made.
The diagram in Figure 3.2 shows the relationship between mounting tolerances and possible dynamic load capacity.
AXC120
AXC100 / AXF100
AXC80
AXC60
0,00
0,02 0,04 0,06 0,08 0,10 0,12 0,14 0,16 0,18 0,20 0,22 0,24 0,26 0,28 0,30
100 000
90 000
80 000
70 000
60 000
50 000
40 000
30 000
20 000
10 000
0
Mounting tolerances
Dy
na
m
ic l
oa
d c
ap
ac
ity [
%
]
Summary of Contents for AXC100Z
Page 1: ...www ntn snr com NTN SNR LINEAR MOTION LINEAR AXIS With You ...
Page 8: ...6 ...
Page 242: ...240 Notes ...