NTI VEEMUX AUDIO VIDEO MATRIX SWITCH VIA CAT5
29
ETHERNET CONTROL
Telnet Interface-Port 2000
Note: Before Telnet can be used, it must first be enabled using the WEB interface (page 38).
The Telnet Interface enables the user to control the switch using telnet client through an Ethernet connection. The telnet server
listens on ports 2000 and 2005. Port 2000 is for an operator telnet session while port 2005 (must be enabled) is intended for a
software control type session (see page 30). For operator telnet control using the telnet interface and the current IP address,
type the following in a command shell:
telnet 192.168.1.30 2000
The VEEMUX will prompt the user for a password. The user must enter the password followed by <Enter>.
The factory default password is
"nti".
With a proper password sent the VEEMUX will respond with:
Password Successful
Connection Established
The commands below are now available.
Telnet Interface- Port 2000 Commands
Command
Reply
Description
H(elp) or h(elp)
Displays the list of commands
Help
CS nn,mm
*<CR>
Connect One input nn To output mm
CA nn
*<CR>
Connect All Outputs To Input nn
RO mm
*<CR>nn<CR>
Read Connection For Output.
Returns the number of the input nn connected to output mm
CC nn
*<CR>nn<CR>
Save Matrix Connections Into Memory Bank nn
nn should be between 00 and 99
RC nn
*<CR>nn<CR>
Restore Matrix Connections From Memory Bank nn
nn should be between 00 and 99
CB nn
*<CR>
Change baud rate of serial line, nn=12(00),24(00),48(00),96(00)
Factory default is 9600.
RV 00
*<CR>string<CR>
Read NTI Version String
RU
*<CR>nn,mm<CR>
Read Unit Size
Returns the number of inputs nn and the number of outputs mm
RS *<CR>
Reset
Unit
CP
User is prompted to introduce
the password twice
Change password- five (5) characters minimum
<Ctrl>-<X>-<Enter>
Good Bye.
Connection to host lost.
Quit telnet session
H(elp) or h(elp)
Displays the list of commands
Help
Notes:
1.
The commands must be typed exactly as shown in the chart. The commands are case sensitive.
2.
If a mistake is made, the user must backspace to the beginning and completely retype the command.
3.
If a command is sent that the VEEMUX does not recognize or exceeds the configuration of the switch, the
reply "?" may be received. Check the command syntax and try again.
