NTI VEEMUX AUDIO VIDEO MATRIX SWITCH VIA CAT5
12
Connect to the Ethernet
If the Telnet Interface (page
29
) or Web Interface (page
34
) will be used to remotely control port connections, an Ethernet
connection to the Local Area Network (LAN) must be made using CATx cable with RJ45 connectors attached. Wiring between
connectors should be straight through (pin 1 to pin 1, pin 2 to pin 2, etc.) Connect a CATx cable between the connector labeled
"ETHERNET" and the LAN (see Fig. 4).
Figure 6- Connect the VEEMUX to the LAN
Serial Connection
If control via serial connection is going to be used, serial control can be achieved using the “USB Console” port or the “RS232”.
To use the “RS232” port
, connect one end of a CAT5 patch cable (supplied) to the port labeled “RS232” on the rear of the
VEEMUX. Plug the other end of the CAT5 cable into an RJ45-to-DB9 adapter (supplied), and connect the adapter to the RS232
port on the control terminal. Follow the instruction under “RS232 Control” on page
23
for configuration and use of the RS232
control feature.
Figure 7- Serial Connection via RS232
