NTI VEEMUX AUDIO VIDEO MATRIX SWITCH VIA CAT5
15
To quickly change a connection
, use one of these scenarios:
Press the
Out
button and the desired port number followed by the
In
button and desired port number. Then press
Enter.
Press the
In
button and the desired port number followed by the
Out
button and desired port number. Then press
Enter
.
Multiple displays can be connected to a single video source using one command sequence:
<
In
> xx<
Out
>xx<
Out
>xx<
Out
>xx<
Out
>xx<
Enter
> or
<
Out
>xx<
Out
>xx<
Out
>xx<
Out
>xx <
In
> xx <
Enter
> (where xx is the port number)
To configure the VEEMUX, use the Menu keys.
Press the
List
button to list your main menu options:
1- Serial
2- Ethernet
3- DDC
4- Standby
5- Save Config
6- Load Config
7- VU Meter
8- LCD Contrast
Use the
Up
and
Down Arrow
keys to scroll through this list.
Use the
Enter
Key to select a menu item.
Press the
List
button again to exit the menu.
If, while in a menu, you pause for more than 5 seconds, you will automatically exit the menu.
LCD Menus
1. Under the “Serial” menu are two parameters:
1- Baud rate
2- Address
These parameters are used when the VEEMUX is controlled through an RS232 connection (page
23
). If you select Baud rate,
use the arrow keys to toggle through the available baud rates. The baud rate can be set to 115200, 57600, 38400, 19200, 9600,
4800, 2400, or 1200.
If you select Address, use the arrow keys to toggle through the address options (01-15). This is also the switch address used in
conjunction with the IR Remote operation (page
53
).
2. Under “Ethernet” menu are several parameters:
1- Mode
2- IP
3- Mask
4- Gateway
5- Preferred DNS
6- Alt. DNS
