NTI SERIMUX SERIES CONSOLE SWITCH
31
Figure 28- Last confirmation before firmware update
6. Using the terminal program, send the binary firmware file using “
1K Xmodem
” protocol.
Figure 29- File transfer in progress
7. After successful transmission the SERIMUX will automatically restart after few seconds. If not, power down the SERIMUX,
power it back ON, and press [
Enter
[.
Note: Be sure that the baud rate setting of the terminal program is the same as that last configured in the SERIMUX. If
you cannot remember what the baud setting was, see “Reset SERIMUX Console Switch to default settings” on page 35.
If the firmware update failed or was interrupted for any reason, power cycle the SERIMUX and repeat the procedure beginning at
step 4.
