LinMot Installation Guide
6.13
S5
S5
Bus Termination / AnaIn2 Pull Down
S5
Switch 1: AnIn2 Pull down (4k7 Pull down on X4.4). Set to ON, if X4.4 is used as digital Output.
Switch 2: Termination Resistor for RS485 on CMD (120R between pin 1 and 2 on X7/X8) on/off
Switch 3: CAN Termination on CMD (120R between pin 7 and 8 on X7/X8) on/off
Switch 4: CAN Termination on ME (120R between pin 7 and 8 on X10/X11) on/off
Factory setting: all switches “off”
6.14
LEDs
LEDs
State Display
Green
Yellow
Yellow
Red
24V Logic Supply OK
Motor Enabled / Error Code Low Nibble
Warning / Error Code High Nibble
Error
6.15
RT BUS LEDs
RT Bus LEDs
RT Bus State Display
Green
Red
OK
Error
The use of these LEDs depends on the type of fieldbus which is used. Please see the corresponding
manual for further information.
6.16
S1 - S2
S1 - S2
Address Selectors
E12x0 V1
E12x0 V2
S1 (5..8)
S2 (1..4)
Bus ID High (0 … F). Bit 5 is LSB, bit 8 MSB.
Bus ID Low (0 … F). Bit 1 is LSB, bit 4 MSB.
The use of these switches depends on the type of fieldbus which is used. Please see the corresponding manual for further
information.
NTI AG / LinMot
®
www.LinMot.com
Page 14/20
E
1
2
0
0
In
s
ta
lla
ti
o
n
G
u
id
e
