NR Electric RCS-9698G, Instruction Manual

Page: 40 / 81

Chapter 4 HMI Operation Introduction
NR ELECTRIC CO., LTD. 30
is displayed after the device is powered up or reset as shown in the following figure.
Figure 4.2-1 Readiness screen of RCS-9698H
Items Signification:

Date/Time: Current system time and date.

Device information: show device name and type.

Manufacturer name: Emblem of our company.

GPS status: When the device is validly synchronized by an external clock source, it displays
“
S ”, otherwise, it displays “ N ”.

Remote/Local: When the PDB works in local mode, it displays “ L ”; otherwise, it displays “ R ”to
show that the dice works in remote mode.

Native status: When the native equipment works as a HOST MACHINE , it displays “.”; on the
contrary, when the native equipment works as a HOT STANDBY MACHINE , it displays “+”.

Blocking status of counterpart : when the counterpart does not exist, has a power failure or
works as a
HOT STANDBY MACHINE , it displays as “+”; otherwise, it displays “.”. This signal
is obtained by two pairs of hard wire connected to serial port extension board that is plugged
the 7th slot.

Link status between dual device: When the native equipment receives a cyclical handshake
signal (i.e. heartbeat signal) from counterpart sending by a certain Ethernet channel, it
displays “.”to show a good link between dual equipments; if the native equipment does not
receive the heartbeat signal to a certain numbers, it displays “+”to indicate a disconnection
between dual equipments.
4.3 LED Indicators