NVIP-TDN2401D/IR/MPX1.0 - user’s Manual ver.1.0
All rights reserved © AAT Holding sp. z o.o.
11
The recommended way to start an IP camera and its configuration is a connection through crossover
cable with your PC or laptop.
Network configuration of camera can be also performed using NMSiptool.exe or by the NMS software
using camera default IP address: 192.168.1.200. Finding a camera with previously unknown IP address
is also possible with using IPtool.
To get information about your network configuration parameters (not used IP address, gateway,
network mask, etc.) you have to contact your network administrator.
2.4. Parameters configuration by using web browser
The default network settings for NVIP-TDN2401D/IR/MPX1.0 IP camera:
1. IP address=
192.168.1.200
2. Network mask -
255.255.255.0
3. Gateway -
192.168.1.254
4. User name -
root
5. Password -
pass
Knowing the camera IP address you need to set PC IP address in such a way so that the two devices can
operate in one network subnet ( e.g. for IP address 192.168.1.1 then IP address you can set in the
camera ranges from 192.168.1.2 to 192.168.1.254, for example 192.168.1.60). It is not allowed to set
the same addresses for camera and PC computer
You can set network configuration (IP address, gateway, net mask, etc.) of NOVUS IP camera or select
DHCP mode (DHCP server is required in this method in target network) by using web browser or by
NMSiptool application. When you use DHCP server check IP address lease and its connection with
camera MAC address to avoid changing or losing IP address during device operation or network/DHCP
server breakdown. In order to connect to IP camera please remember to use a new camera IP address
after changing network parameters.
After network setting configuration has been done, the camera can be connected to a target network.
START-UP AND INITIAL CAMERA CONFIGURATION
Cross-over cable
IP camera
PC
