NOVUS AUTOMATION
24/28
8.3.3.2
ALARM OUTPUT CONFIGURATION
To select the alarm output to be configured, you must click on the button
and enable it by sliding the enable switch to the right.
Fig. 16
– Alarm
The alarm output may be timed by the
Time On
and
Time Off
parameters.
If the equipment is configured in the
Value Lower than SPLo
,
Value Higher than SPHi
,
Inside the Range
or
Outside the Range
modes, the
Error Condition
parameter allows you to configure a safe state of the alarm output in case of sensor failure. Thus, the output will be on or off
depending on the value set in this parameter.
Upper Limit
and
Lower Limit
are the differential pressure values that act as alarm activation conditions that, together with the
Hysteresis
, define
the barrier to be exceeded so that the channel exits the alarm situation. For more information about the alarm configuration, check the
section.
www.
GlobalTestSupply
.com
Find Quality Products Online at:
