NOVUS AUTOMATION
23/28
8.3.3
OUTPUT PARAMETERS
By clicking on the
icon, you can configure the transmission analog output and the alarm output.
Fig. 14
– Output configuration screen
8.3.3.1
TRANSMISSION OUTPUT CONFIGURATION
Fig. 15
– Output
The
Measurement
parameter allows the differential pressure quantity reading.
The analog output
Mode
allows you to select the electrical standard to be used for the transmission: 0-10 V or 4-20 mA. The electrical signal of the
output will be proportional to the selected magnitude, respecting the values configured in the
Lower Limit
and in the
Upper Limit
parameters.
In case of sensor failure, the quantity to be transmitted by the analog output will go into
Error Mode
. For the error condition, you must select the
High
,
Low
or
Low-High
state (check
Table 03
).
www.
GlobalTestSupply
.com
Find Quality Products Online at:
