02/17 Rev. 02
SERVICE MANUAL
Attachment, Setup, Service
Rewinder
2000
33
(AP 5.x / XLP 50x) Run-in roller for
narrow labels
To improve the guiding accuracy of
AP 5.x/XLP 50x printers processing very narrow
label material, it is recommended to install an
additional run-in roller (1) (article number
A100422).
At older rewinders, an additional hole according
to fig. (2) must be drilled before installing the run-
in roller.
Tools:
2/2.5 mm allen keys
Assembling:
Screw the axle of the run-in roller to the
hole as illustrated (1).
Adjusting:
1. Measure the centre of the label material
and mark it (3).
2. Loosen the set screw (4).
3. Shift the roller on the axle until the centre
groove on the roller (5) is in front of the
mark (3) on the material.
4. Re-tighten the set screw (4).
Material path:
Insert the material so that it runs
over
the
roller (6).
1
2
3
4
5
6
23.50
30.50
R4.40
R2.10
Countersunk 90°
