02/17 Rev. 02
SERVICE MANUAL
Attachment, Setup, Service
Rewinder
2000
12
Adjusting the sensor
The dancer arm controls the winding speed of the rewinder by means of a
sensor. Bevor applying the rewinder for the first time, the dancer arm has to
be brought in both end positions to adjust the sensor.
[4] Left side: dancer arm in zero position; right side: dancer arm in final position.
Action
Display
Note
1. Select
parameter
SERVICE
FUNCTION > Rewinder adjust
Rewinder adjust
If 0 jobs are stored in
memory.
2. Press the Online button
Rewinder adjust
Resting pos. xx
xx = actual value
supplied by the sensor;
moving the dancer arm
alters the value
3. Move the dancer arm appr.
5 mm out of its resting
(zero) position. Press the
Cut button.
Rewinder adjust
End pos. xx
Mind the notes
following this table!
4. Move the dancer arm up to
the stop plate i the direction
of the support leg, and then
back again by approx.
5 mm. Press the Enter
button.
Rewinder adjust
Mind the notes
following this table!
5. Repeatedly press the Prog
button until
OFFLINE 0 JOBS
Set the value approx. 5 mm before reaching the final or zero position,
respectively!
Press the Cut button in the resting position but the Online button in the end
position!
CAUTION! - If programming is interrupted by pressing the Esc-button, the
printer uses preset values which may cause the device to malfunction!
