02/17 Rev. 02
SERVICE MANUAL
Attachment, Setup, Service
Rewinder
2000
21
Starting / Stopping
After securing the material end, proceed as follows to start printer and
rewinder:
The printer is set to offline mode (respectively “Home”-screen for XLP 50x).
TTX 350 / TTK
Starting
1. Press the CUT button.
The rewinder starts rewinding, until the dancer arm reaches the final
position. At that point, the rewinder stops.
2. Switch the printer online.
If a printjob has already been loaded, both printing and rewinding start
nearly simultaneously.
Stopping
Start or stop the rewinder by pressing the CUT button. This works in online
mode as well as in offline mode.
Material end
With no material to rewind, the rewinder stops after approx. 4 s and shows
the status report:
ST13
Press the ON/OFF button to acknowledge the status report.
64-xx / AP 5.4 / AP 7.t
Starting
1. Press the Cut button
The rewinder starts rewinding, until the dancer arm reaches the final
position. At that point, the rewinder stops.
It is essential to let the dancer arm initially reach its final position after
starting. Only then, the dancer arm takes control over the rotation speed
(explanation below).
2. Switch the printer online.
If a printjob has already been loaded, both printing and rewinding start
nearly simultaneously.
Stopping
Start or stop the rewinder by pressing the Cut button. This works in online
mode as well as in offline mode.
Material end
With no material to rewind, the rewinder stops after approx. 6 s and shows
the status report:
Status 5004
Rewinder mat. tear
Press the Online button to acknowledge the status report.
