02/17 Rev. 02
SERVICE MANUAL
Attachment, Setup, Service
Rewinder
2000
9
Adjusting the sensor
The dancer arm controls the winding speed of the rewinder by means of a
sensor. Bevor applying the rewinder for the first time, the dancer arm has to
be brought in both end positions to adjust the sensor.
[2] Left side: dancer arm in zero position; right side: dancer arm in final position.
Action
Display Note
1. Select
parameter
SYSP > PEPH
.
PEPH
2. Press the ENTER button
RWND
If the rewinder has already been
set.
3. Repeatedly press the CUT button
until
RADJ
4. Press the ENTER button
RNUL
Initially setting of the sensor with
the dancer arm in the zero
position. (See fig. above left)
5. Press the ENTER button
xxx
xxx = actual sensor value; the
displayed value is altered by
moving the dancer arm.
6. Move the dancer arm appr. 5 mm
out of the zero position. Press
the ENTER button.
REND
7. Press the ENTER button
xxx
xxx = actual sensor value; the
displayed value is altered by
moving the dancer arm.
8. Move the dancer arm up to the
stop plate in the direction of the
support leg, and then back again
by approx. 5 mm. Press the
ENTER button.
RWND
9. Repeatedly press the
CUT+FEED button until
OFF
Set the value approx. 5 mm before reaching the final or zero position,
respectively!
CAUTION! - If programming is interrupted by pressing the CUT+FEED
button, the printer uses preset values which may cause the device to
malfunction!
