04/13 Rev. 1.12-02
USER / SERVICE MANUAL
Mounting/Setup
LA-TO / LA-TO XL
Settings
23
Adjusting the end position
This setting is only required, if the applicator is driv-
en sensor controlled, what means that
Applicator type
=
„LA-TO Sensor“. With the alternative setting „LA-TO
Timed“, this sensor signal is not interpreted.
As soon as a label is transferred from the vacuum plate,
the vacuum plate moves downwards to the final posi-
tion.
The final position is determined solely by the adjustable
final position sensor. By moving the sensor, you can
change the height of the final position and adjust it to
suit your specific needs.
Tool
Small screwdriver (0.6x4 mm)
Adjusting the end position of the sensor:
1. Unplug the compressed air line.
2. Place the product to be labelled beneath the
LA-TO.
3. Push the vacuum plate slowly downwards until it is
lying on the product.
4. If necessary, loosen the clamping bolt [30A] and
push the transfer sensor along the pneumatic cylin-
der until the LED on the sensor lights up.
5. Fasten the sensor by retightening the clamping
bolt.
Adjust this setting according to the operating speed
of your applicator to prevent the applicator plate from
‘hammering’ too severely against the product.
For high operating speeds, move the sensor slightly
upwards.
[30] Adjusting the end position
A
