Novell PLATESPIN ORCHESTRATE 2.0.2, Installation And Configuration Manual, Page: 48 / 132

48 PlateSpin Orchestrate 2.0 Installation and Configuration Guide
no
vd
ocx
(e
n)
13
Ma
y 20
09
NOTE: The remaining steps in this procedure show the installation of the Orchestrate Agent as
an example of component installation. Steps for installing any of the other components are
similar. Refer to
Section 2.2.2, “PlateSpin Orchestrate Configuration Information,” on page 30
for further information you might need to configure a component.
6 (Conditional) If you use the PlateSpin Orchestrate product configuration script, run it from the
command line.
6a Make sure the product ISO is accessible. The script copies some files from the ISO.
6b
Make sure you are logged in as
root
to run the configuration script.
6c Run the script, as follows:
/opt/novell/zenworks/orch/bin/config
When the script runs, the following information is initially displayed:
Welcome to PlateSpin Orchestrate.
This program will configure PlateSpin Orchestrate 2.0
Select whether this is a new install or an upgrade
i) install
u) upgrade
- - - - - -
Selection [install]:
6d
Press Enter to select the default (install) and display the following text, depending on
which components you installed previously:
Select products to configure
# selected Item
1) no PlateSpin Orchestrate Monitoring Service (not installed)
2) no PlateSpin Orchestrate Server (not installed)
3) yes PlateSpin Orchestrate Agent
4) no PlateSpin Orchestrate VM Builder (not installed)
Select from the following:
1 - 4) toggle selection status
a) all
n) none
f) finished making selections
q) quit -- exit the program
Selection [finish]:
6e Type f and press Enter to finish the selection of the Orchestrate Agent (for this example,
only the Orchestrate Agent is installed).
6f Specify the name of the Orchestrate Agent on this node, then press Enter.
6g Specify the hostname or IP address of the Orchestrate Server, then press Enter.
6h Specify (yes or no) whether you want to use a certificate for verifying communication,
then press Enter.
6i Specify (yes or no) whether this is a virtual machine, then press Enter.
6j Specify the port on the Orchestrate Server that you want to use for communication
between this Agent and the Server, then press Enter.