Chapter 10 Troubleshooting
SMART7 Installation and Operation User Manual v6
116
1. Log the
RXSTATUS
log and check Bit 1 of the Receiver Status word.
LOG RXSTATUS onchanged
<RXSTATUS USB1 0 81.5 FINESTEERING 1990 326146.020 0a104020 2ae1 14434
< 00000000 5
<
0a104020
00000000 00030000 00030000
(Receiver Status)
< 00062000 00001008 00000000 00000000
< 00000000 00000000 80000000 00000000
< 80000000 00000000 00000000 00000000
< 00000000 00000000 00000000 00000000
For information about reading the Receiver Status word, refer to
2. If Bit 1 is 0, the temperature is okay. Continue monitoring, but no action is required.
If Bit 1 is 1, the receiver temperature has exceeded the warning limit.
3. Log the
HWMONITOR
log and check the two temperature status fields (0x01 and 0x16).
LOG HWMONITOR ontime 30
<HWMONITOR USB1 0 77.5 FINESTEERING 1990 326851.000 0a104020 52db 14434
< 10
<
58.424915314 100
(Temperature 0x01)
< 0.000122100 200
< 3.296703339 600
< 5.169230938 700
< 1.192307711 800
< 3.300366402 f00
< 1.833943844 1100
< 5.159462929 1500
< 1.555555582 1700
<
58.485961914 1600
(Temperature 0x16)
Pay attention to the reading and the boundary limit status.
Refer to Table: HWMONITOR Status Table in the
HWMONITOR
log section for a description of the Bound-
ary Limit Status.
4. Use the suggestions in
Mitigating High Receiver Temperature
on the previous page to reduce the receiver
temperature.
5. Continue monitoring the
HWMONITOR
log to see if receiver temperature is dropping.
6. Check the
RXSTATUS
log to see if the temperature status changes to Okay (Bit 1 in the Receiver Status
word changes to 0).
10.4 Safe Mode
Safe Mode is an error condition triggered on the OEM7 receiver if it encounters certain critical problems during
start-up. The receiver does not track GNSS satellites in this state, but the user interface is still available to allow
for diagnosis of the problem.
The receiver will enter Safe Mode under certain rare cases including the following:
