background image

2

1

ST  5.5x50 (x3)

W-A

 

concrete  anchor 

W-B

(x3)

Package  M

Package  W

M4x14 

M-A

(x4)

M5x14  (x4)

M-B

D4  washer 

M-C

(x4)

D  

(x4)

5 washer 

M-D

3mm  Allen  key  (x1)

M-E

NOTE:

  Read  the  entire  instruction  manual  before  you  start  installation  and  assembly.

Component  Checklist

WARNING

•  Do  not  begin  the  installation  until  you  have  read  and  understood  the  instructions 
    and  warnings  contained  in  this  installation  sheet.  If  you  have  any  questions 

    regarding  any  of  the  instruction  or  warning,  please  contact  your  local  distributor.

•  This  mounting  bracket  was  designed  to  be  installed  and  utilized  ONLY  as 
    specified  in  this  manual.  Improper  installation  of  this  product  may  cause  damage 

    or  serious  injury.

•  This  product  should  only  be  installed  by  someone  of  good  mechanical  ability, 

    with  basic  building  experiences  and  fully  understanding  of  this  manual.

•  Make  sure  that  the  supporting  surface  will  safely  support  the  combined  load  of 
    the  equipment  and  all  attached  hardware  and  components.

•  If  mounting  to  wood  wall  studs,  make  sure  that  mounting  screws  are  anchored 
    into  the  center  of  the  studs.  Use  of  a  stud  finder  is  highly  recommended.

•  Always  use  an  assistant  or  mechanical  lifting  equipment  to  safely  lift  and  position 

    equipment.

•  Tighten  screws  firmly,  but  do  not  over  tighten.  Over  tightening  can  damage  the 
    items,  greatly  reducing  their  holding  power.

•  This  product  intended  for  indoor  use  only.  Using  this  product  outdoors  could 
    lead  to  product  failure  and  personal  injury.

IMPORTANT: 

Ensure  that  you  have  received  all  parts  according  to  the  component  checklist  prior  to  installing.  If 

                                                                  any  parts  are  missing  or  faulty,  telephone  your  local  distributor  for  a  replacement.

Summary of Contents for MONWM3










Reviews: