background image

I N S T A L L A T I O N   I N S T R U C T I O N S

Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes

no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.

Chief Manufacturing, a products division of Milestone AV Technologies

8401 Eagle Creek Parkway, Savage, MN 55378

• P: 800.582.6480 / 952.894.6280   • F:877.894.6918 / 952.894.6918

8800-002127 Rev00

©2011 Milestone AV Technologies,

a Duchossois Group Company

09/11

SSB-298, SSM-298, SLB-298 and SLM-298 Interface Brackets

SSB-298, SSM-298, SLB-298 and SLM-298 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.

Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.

WARNING:

IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND

DAMAGE TO EQUIPMENT!

 DO NOT substitute hardware. Use only hardware supplied by manufacturer!

Installation Instructions

WARNING:

OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND

DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface brackets.

NOTE:

Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.

1.

Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.

2.

Turn projector upside down on a flat surface.

3.

Place the interface bracket onto the bottom of the projector, aligning the mounting holes in the bracket with the threaded inserts in the
bottom of the projector and ensuring that triangle in bracket points towards front of projector.

4.

Position M4 x 12mm mounting screws with M4 flat washers into the bracket and threaded inserts. Tighten all fasteners at this time, securing
the bracket to the projector.

NOTE:

Security screws can be substituted when mounting Interface bracket to projector by using the parts and installation instructions in the
All-Points Security Kit.

Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.

(1)  Interface Bracket

(4)  Screw, Phillips Pan Head, Machine, M4 x 12mm

(6) 10-24 Thumb Nuts **

(4)  Washer, M4

(1)  All-Points Security Kit

(1)  5/32" Security Hex Key

        **Only used when installing SLB/SSB interface brackets.

NOTE:

Specific to SSB-style and SSM-style interface bracket installation: All appropriate screws come pre-installed in the circled locations above.

DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style interface bracket installation.

Note: SSB-style interface bracket connections are circled.

Note: SSM-style interface bracket connections are circled.

SLB-298

SLM-298

Towards front
of projector

Towards front
of projector

Reviews: