Nortec GS Series GSP Indoor, Engineer'S Manual

Page: 12 / 46

10-00
Page 5
2008-10-01
Table 2. Standard Features
Standard Features GSTC GSP*
Steam Capacity adjustment x
Full size alphanumeric display and keypad x
Total Controller with Modbus host protocol x
Transducer signal acceptance x
Individual component diagnostic capability x
Keypad set-point adjustment (humidity) x
Display of relative humidity x
Low and high relative humidity alarms x
Adjustable drain with no call for humidity x
Keep warm feature x
Networking capability up to 10 units x
Pre-cleaning sequence x
Troubleshooting Guide x
Self diagnostic capabilities x
Fault history x
Smart drain water cooling x
On/off cycling prevention x
Full tank blowdown capability via timer or external trigger x x
Board mounted display for fault and demand indication not req. x
Parameter change through jumper settings keypad x
Remote fault indication x x
Single or Dual modulation signal acceptance x x
Industry standard modulation signal acceptance x x
Time to next maintenance alarm x x
Internal Drain water cooler x x
System demand indication x x
Output display x x
Precise five level water level indication x x
Status indicator lamps x x
Backlit display x x
B or BH venting options x x
BH stack vent (outdoor only) x
Large Side tank cleaning port x x
Top access cleaning (300, 400, 500 & 600 lb models) x x
Single water connections x x
Turn-down ratio from maximum output to 25lbs/hr(11kg/hr) x x
Time proportioning below 25lbs/hr(11kg/hr) x x
120V or 208-240V power supply x x
Freeze Protection (Outdoor only) See Section 10-30, Page 24. x
Integral enclosure (outdoor only) x
Nortec Links Building Management System capable using BACnet
or LonWorks N2 protocols
o o
Nortec OnLine for web based monitoring and control o
Sealed combustion / Direct vent o o
Floor stand o o
Distribution Systems
Short Absorption Manifold SAM-e o o
Steam Distributor o o
Blower Pack o o
x = standard o = optional