Nordson Sure Coat, Manual

Page: 50 / 91

Operation
A 5-10
Part 331235C
E 2003 Nordson Corporation
Part A: System Overview
Restoring Factory Default Settings
If you are not satisfied with the settings that you have set up for your
system, you may restore the modular gun control system to its factory
default settings.
Table A 5-7 Restoring Factory Default Settings
To Restore Press These Keys
Default set points to the gun that
you are viewing on the display
STD and Nordson
Default set points to all guns in the
system
SET ALL, STD, and Nordson
All defaults set at the factory,
including all set points, gun
mapping sequence, pneumatic
type, etc.
STD and Nordson while the
system is powering up
Shutdown
1. Stop triggering all guns in the system.
NOTE: If the control system is wired to the booth electrical panel, you may
leave the control system power switches in the on position. The control
system will automatically turn on and off when the booth power is turned on
and off.
2. Turn the main power switch on the rear of the main control cabinet.
NOTE: Turning the power switch on the main control cabinet to the off
position shuts down the main control cabinet and central control unit. It
is not necessary to turn the central control unit power switch to the off
position.
3. Ground the gun electrodes to discharge any residual voltage.
4. Perform the
Daily Maintenance procedure in this manual and all other
system component manuals.