Nordson Sure Coat, Manual

Page: 38 / 91

Configuration
A 4-4
Part 331235C
E 2003 Nordson Corporation
Part A: System Overview
Gun Mapping
(contd)
1. Enter the configuration mode. Refer to Entering Configuration Mode for
instructions.
2. Press the A key (14). ASSIGN GUN scrolls across the display (8), then
the numeral 1 appears. The gun select LED (3) on the gun keypad
currently programmed to control gun number 1 lights.
3. If you want to change the physical location of gun 1, press the desired
new physical location’s gun select key (4). The gun select LED lights to
indicate the gun’s new location.
4. Press the + key (9) until the next gun number that you want to assign
appears in the display. The gun select LED lights to indicate the gun’s
current location.
5. Press the desired new physical location’s gun select key. The gun
select LED lights to indicate the gun’s new location.
6. Repeat steps 4 and 5 to assign as many guns as necessary.
NOTE: If you have an odd number of guns in your system, one location
must be empty. For example, if your system has eight gun driver cards
and only 15 guns, you must make sure that gun 16 is not assigned to
any physical location. When 16 appears on the display, press the
corresponding gun select key to remove gun 16 from the central control
unit.
7. Record the location of the guns using the gun location labels (2).
8. Use the +/
− keys to check the numbering sequence of the gun keypads.
As each sequential number appears on the display, the corresponding
gun select LED will light to indicate the physical location of each gun.
NOTE: To continue on to another configuration mode, press the
corresponding configurable option key. Configurable option keys are
indicated by blinking LEDs.
9. To exit the configuration mode, press the Nordson key (15).