Configuration
A 4-2
Part 331235C
E
2003 Nordson Corporation
Part A: System Overview
Entering Configuration Mode
NOTE:
System power must be on in order to enter the configuration mode.
Refer to the
Operation
section in this part of the manual.
NOTE:
Make sure that the central control unit is in Local mode before
performing any configuration procedures. See Figure A 4-1. If the LED on
the LOCAL key (11) is lit, the central control unit is in Local mode. If the
LED is not lit, press the LOCAL key.
1. See Figure A 4-1. Press the Nordson key (15).
2. When three dashes appear in the display (8), press the PGM key (16).
CHOOSE CONFIG scrolls across the display and LEDs blink on the
keys that correspond to the configurable options.
3. Refer to Table A 4-2 for a list of the system’s configurable options.
Press the key listed in the Key column to configure its corresponding
option. Instructions for configuring each option are explained in the
procedures listed in the Refer to column.
Table A 4-2 Configurable Options
Key
Option
Refer to
A
Program gun location on the
central control unit
Gun Mapping
B
Program system pneumatic
module type
Pneumatic Type
AFC
Enable/disable set point
adjustments in Select
Charge AFC
Select Charge AFC
Enable/Disable
ALL
Lock out all set point
adjustments
Set Point Lockout
4. To exit the configuration mode, press the Nordson key.
Summary of Contents for Sure Coat
