Nordson Sure Coat, Manual

Page: 35 / 91

Configuration
A 4-1
Part 331235C
E 2003 Nordson Corporation
Part A: System Overview
Section A 4
Configuration
WARNING: Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
Introduction
You can customize the central control unit to fit the needs of your specific
application. These procedures should only be necessary when the system
is first installed. However, you may also perform these procedures to
change your system to fit changing application requirements.
Restoring Factory Default Settings
If you are not satisfied with the settings that you have set up for your
system, you may restore the modular gun control system to its factory
default settings.
Table A 4-1 Restoring Factory Default Settings
To Restore Press These Keys
Default set points to the gun that
you are viewing on the display
STD and Nordson
Default set points to all guns in the
system
SET ALL, STD, and Nordson
All defaults set at the factory,
including all set points, gun
mapping sequence, pneumatic
type, etc.
STD and Nordson while the
system is powering up