Instruction Sheet
P/N 1029716A
RTD Service Kit - P/N 1028320
Use this service kit to replace either the tank or the manifold RTD. The kit
contains a ceramic terminal block that must be installed the first time you
replace either RTD.
WARNING: Risk of personal injury or equipment damage! Refer to
the safety information provided in the melter manual before servicing
the melter. Failure to comply with the safety information provided
can result in personal injury, including death.
Tools:
Wire cutters
Small flat-tip screwdriver
2.5-mm hex wrench
6-mm hex wrench (For manifold RTD only)
Terminal Block
RTD
Thermal Compound
O-ring
O-ring
1.
Switch the melter off.
4.
Strip the ends of the existing
RTD wires and then connect the
wires to the top terminals on the
terminal block. Tighten the terminal
screws.
5.
Coat the new RTD with
thermal compound and then insert the RTD into
the slot until it stops.
Replacing the Tank RTD
2.
Cut the wires on the failed
RTD just behind the RTD and then
pull out the RTD.
6.
Trim the new RTD wires
approximately 100 mm (4 in.) from
the RTD, strip the ends of the wires,
and then connect both wires to the
bottom terminals on the terminal
block. Tighten the terminal screws.
3.
Attach the terminal block to the bracket
using the 3-mm hex-head screw and
matching lock washer.