17
www.nordsonefd.com [email protected]
800-556-3484 Sales and service of Nordson EFD dispensing systems are available worldwide.
Safety Enclosure for Automated Dispensing Systems
Initial Startup
NOTE:
This startup procedure applies only to the first power-on of the enclosure after installation. For routine
operation, refer to “Operation” on page 19.
1.
Verify that the 24V voltage supply switch inside the
electrical box is set to the correct voltage.
AC supply
voltage switch
2.
Ensure that:
• All system cables are properly connected as applicable for your installation.
• The dispensing system installation is complete.
3.
Connect the 5 m safety enclosure power cable to the
power inlet on the right side of the enclosure and to
the power source.
4.
Turn the main disconnect switch located on the back
of the safety enclosure to the ON position.
When the system is powered on, the light curtain and
all I/O connections are automatically active.
If the light curtain is interrupted by any passing object
(such as a hand reaching into the enclosure), the
system enters an emergency stop condition.
Location of the light curtain
beams and sensors
Continued on next page
Installation (continued)