Page 108
Page 109
DE
EN
12 Cleaning
Prior to cleaning, pull out the mains plug and switch off the device!
You must not use scouring pads, scouring powder and solvents such as alcohol or petrol.
Do not use any of the following substances: Salt water, insecticides, solvents containing
chlorine or acids (ammonium chloride).
Clean the housing using a soft, damp cloth. Do not use spirit, thinners, etc.; you could
damage the surface of the device.
Only clean the display with a soft cotton cloth. If required, use a cotton cloth with small
amounts of non-alkaline, diluted, water-based or alcohol-based soap solution.
Gently clean the surface using the cotton cloth.
All previously stored stations and settings will now be deleted. The device is now in the
same status as when delivered.
>
The display will show
[Restart ...]
and the device will start with the language selection
[Language]
. Use the
Tune/Select
knob to select one of the available languages and
confirm the selection by pressing the
Tune/Select
knob. The device then automatically
performs a complete scan in DAB mode. While scanning, the display information shows
the progress as well as the number of digital radio stations detected. After completing the
station scan, the first DAB+ channel is played.
11.6 SW version
Under SW Version you can check which SW version is currently installed.
>
Open the
[System]
sub-menu as described in Section 11.
>
Use the
Tune/Select
knob to select the
[SW Version]
menu item. Press the
Tune/
Select
knob to confirm.
>
The current software version is displayed.
