![background image](http://html1.mh-extra.com/html/nordforest/42-295/42-295_instruction-manual_1701457005.webp)
5
EN
Instruction manual
Wire rope cutter 42-295
For fl exible wire ropes up to max. Ø 30 mm.
Stainless and high compressed wire ropes up
to max. Ø 25 mm
Do not live working!
Switch off current!
No extremities near the blades!
Use
• Release hand lever 1 by turning locking knob 3 in position
ON.
• Hold handle 1 fully open and turn locking knob 2 in position
OPEN. It is now possible to turn the pivoted blade 4 as
required.
• Insert the wire rope and turn the pivoted blade 4 until the
edge of the blade rests on the wire rope. Turn locking knob
2 in position CUT. Do not cut angularly!
• Squeeze the handles to manually operate the pivoted blade
4 during the cutting process.
• Releasing the pivoted blade 4 is possible during cutting
proceeding as follows: Squeeze handles 1 (both halves)
together and turn locking knob 2 in position OPEN, open
handles 1 until the block and turn back the pivoted blade 4.
In some cases release the pivoted blade 4 by a blow (with
an plastic hammer) on the point x.
• Lock lever 1 by turning the locking knob 3 in position OFF
during squeezing both handles.
Maintenance
• Oil movable parts.
• Brush ratchet teeth.
General safety instructions
Please read the instruction manual before using the tool and
use the tool only for the specifi ed application. Please obser-
ve the instructions during the use and keep the safety inst-
ructions next to the tool. NORDFOREST assumes no liability
for damages or injuries caused by unsafe use of the tool,
defective maintenance or faulty application. The tool must
only be used by instructed professionals. The tool must only
be repaired from the manufacturer. For works of external
staff we assume no liability. Use only original NORDFOREST
spare parts! If not, claims of the warranty declaration expires.
15-277_SCSZ30_Nordforest.indd 5
15-277_SCSZ30_Nordforest.indd 5
29.10.2015 13:03:20
29.10.2015 13:03:20