nord 6052902/0213, Manual With Installation Instructions

Page: 48 / 128

Industrial gear units – Manual with installation instructions
48 B 1050 en-3921
8. Evenly tighten the studs or cap screws with an Allen key. Tightening torques can be provided on
request.
9. Place on the belts in sequence. Roughly pre-adjust the tension by increasing the gap between the
axles.
10. Make a belt vibrate by plucking or hitting it with a finger.
11. Point the sensor of the measuring device at the vibrating power drum and read the measurement.
12. Correct the axle spacing as necessary and measure again.
13. To prevent the entry of foreign bodies, fill empty connection holes with grease.
After a running time of 0.5 to 4 hours, check the belt tension again and correct as necessary.
Legend
1: Studs or cylindrical
screws
2: Tapered bushing
3: V-belt pulley
Figure 21: V-belt pulley (disassembled/assembled)