nord 6052902/0213, Manual With Installation Instructions

Page: 88 / 128

Industrial gear units – Manual with installation instructions
88 B 1050 en-3921
Quantity Grease quantity VL [g] Grease quantity KL [g]
SK5.07 110 60
SK6.07 110 60
SK7.07 200 130
SK8.07 200 130
SK9.07 210 170
SK10.07 210 170
SK11.07 220 180
SK12.07 220 180
SK13.07 340 230
SK14.07 340 230
SK15.07 380 240
Table 14: Grease quantities for re-greasing the lower output shaft bearing
5.2.16 Re-greasing the Taconite seal
Input and/or output shafts may be equipped with Taconite seals, depending on the version. Re-
lubricate the Taconite seals with the associated grease nipples on the bearing cover or via the
lubrication line.
Legend
1: Bearing cover 1
2: Grease-filled gap
3: Conical grease nipple
4: Bearing cover 2
Figure 41: Re-grease Taconite seal
The exact lubrication points can be obtained from the order-related dimension sheet. Fill the seal with
grease until clean grease emerges from the grease gap. Remove excess grease.
Recommended grease: Petamo GHY 133N - Klüber Lubrication (see chapter 7.3.1 "Roller bearing
greases")
Information
Optimal re-lubrication is achieved by rotating the gear unit shaft in 45° steps when lubricating and
pressing in grease, until clean grease emerges from the shaft.